Gyro Relocation & Structural Re-Engineering

Move your marine gyro to a new location with full structural recalculation, custom bracket design, and performance optimization. Independent engineering for vessels undergoing refit, repower, or interior redesign.

Why Relocate a Marine Gyro?

Gyroscopic stabilizers are precision-engineered to perform optimally at a specific location aboard your vessel. When that location needs to change — due to repowering, interior redesign, weight redistribution, or performance issues — relocation requires more than physical moving. It demands structural recalculation, custom bracketing, and post-installation sea trial verification.

We handle the full engineering stack: from weight distribution analysis to composite reinforcement to sea trial validation. No dealer required.

Common Relocation Scenarios

Engine room reconfiguration — New engines, gensets, or HVAC require the gyro to move

Interior layout changes — Cabin, salon, or galley redesign conflicts with existing gyro placement

Performance optimization — Moving the gyro to improve roll reduction based on operational data

Weight distribution correction — Addressing trim or list issues caused by original placement

Upgrading to a larger unit — New gyro has different mounting requirements or dimensions

Accessibility improvements — Original location makes service and inspection difficult

The Relocation Engineering Process

Five-phase approach to safe, performance-validated gyro relocation.

Original System Analysis

Document current gyro model, serial, performance data, and mounting structure. Establish baseline roll reduction metrics from existing installation.

New Location Engineering

Structural survey of proposed new location. Weight distribution analysis, stringer load calculation, composite reinforcement specification, and custom bracket design.

Controlled Removal & Transport

Safe extraction from original location using cranes or rigging as required. Unit secured for transport within vessel to new mounting position.

New Mounting Installation

Fabrication and installation of custom mounting bed, brackets, and composite reinforcement. Precision leveling and alignment to manufacturer tolerances.

Commissioning & Sea Trial

System reconnection, startup, and operational testing. Sea trial with before/after roll data comparison to validate performance at new location.

Engineering Capabilities

Structural Recalculation

We calculate stringer loads, bulkhead stresses, and hull deflection for the new mounting location. If reinforcement is needed, we specify exact laminate schedules and materials.

Custom Bracket Design

When off-the-shelf brackets do not fit, we design and fabricate custom mounting solutions in 316 stainless or aluminum, engineered for your specific vessel geometry.

Composite Reinforcement

We specify and install carbon fiber, Kevlar, or glass laminate reinforcement to handle increased point loads from relocated gyro mass and operating forces.

Performance Validation

Post-relocation sea trials with roll angle logging. We validate that performance meets or exceeds pre-relocation metrics — guaranteed.